Two days after the error was called in a technician came out and mended it (at site). So, not much of an answer but thats the facts.Īs a contrast I can mention that we had some trouble with a 46" Samsung LDC at work. They seem to have some trouble finding a replacement module fitting my specific type of the plasma (50" D7) but said it would be worked out eventually. They eventually found out that the DVI-D module in the plasma was broken and will replace it asap. They asked to come and collect it (which they did a couple of days later, brought the plasma as well as the BS3) and have had it since. They arrived to realize they hadn't a clue (they did the same tests as I had already done). I was unable to get it working and had to call in BO-service. If I switch off/on the system after that it will go dark again (till P-MUTE is pressed again).Īctually this is not solved yet. If I press P-MUTE (which I at one point thought was accidently pushed and causing the problem) the green light on the link eye comes on (and stays on). This doesn't really match as the orange light isn't flashing and the "Green light in the like eye" isn't true (in my case). " Fault symptom eye” - No picture & LED on back of BeoSystem 3 blinks green & orange" -> "Green light in link eye" -> "Connect Service Tool and make a flash update" I've checked the BS3 Service Manual (as it is the only manual speking of these lets at all) and the only thing in there about "going orange" at all is (on page 16): I've tried to power cycle the units (independely as well as all together, and by really "pulling the cord", as well). I've tried to disconnect all units connected to the BS3. from system beeing turned on (just as the green led on the BS3-unit turns orange). I also noticed that the green led/light on the IR-eye is turned off after about 5 secs. If I switch channel on the remote the sound "switches channel" (so to speak). The system seems to power up "somewhat" OK as sound (from TV) comes on and sounds right. it switches to orange (and stays that way). I took a closer look and found that the small led by the AC-input on the BS3 lights up green when powered on but after about 5 secs. The display starts up OK (through RS232, you can see it "light up") but now picture appears. Once the system was put back together I get no picture in the display. This time, however, I get a strange result. This typically renders a situation where you are asked to type in the PIN (which I have done a couple of times in the past, which has worked fine). However, during the work the system (both display and BS3) was unplugged for a while. We've done some rearrangements with furniture in one of our rooms where we have a BV4-50/BS3 setup.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |